Setup; General Safety Information; Scope Of Delivery; Installing The Mast - Invacare Birdie EVO Gebrauchsanweisung

4 Setup

4.1 General safety information

WARNING!
– Check all parts for shipping damage before use.
– In case of damage, do not use the equipment.
Contact your Invacare provider for further
instructions.
WARNING!
Risk of Injury
Improper assembly may cause injury or damage.
– Use only Invacare parts in the assembly of this
patient lift.
– After each assembly, check that all fittings
are properly tightened and all parts have the
correct function
– Do not overtighten the mounting hardware.
This may damage the mounting brackets.
There are no tools required to assemble the patient
lift.
If there are any issues or questions during assembly,
contact your Invacare provider.

4.2 Scope of delivery

The items included in your package depend on the models
and configurations available in your country. See 1.1
Introduction, page 4
Lift – incl. base, mast, boom, spreader bar,
A
control unit and actuators
• with foldable mast (1 piece)
• with fixed mast (2 pieces) – base as a
separate part
Hand control (1 piece)
B
1650023-B
Mains cable (1 piece)
User Manual (1 piece)
Battery (1 piece)* – CBJ Care, CBJ1 and CBJ2
only
Lever for manual leg spreader (1 piece)*
Sling (1 piece)*
* Depends on model and/ or configuration
If the lift is delivered with a sling, refer to the user
manual of the sling for use, application, maintenance
and washing instructions.

4.3 Installing the mast

4.3.1 Unfolding the mast

(foldable mast only)
WARNING!
– The mast may be folded for storage or
transporting. Each time the mast is folded, the
mast MUST be properly secured to the base
assembly.
– Check all parts for visible defects or damage
before assembly. In case of any damage, do
not use the product and contact your Invacare
provider.
– Make sure the emergency stop is activated
before assembly or disassembly.
– Take care when lifting components during
assembly. Some parts are heavy. Always
remember to adopt the correct lifting position.
Perform unpacking and assembly operation at floor level.
Setup
9