Attaching The Sling To The Lift; Transferring A Patient From A Bed - Invacare Birdie EVO Gebrauchsanweisung

6.2.1 Attaching the sling to the lift

WARNING!
Risk of Injury
Usage of wrong or damaged slings can cause the
patient to fall or cause injury to assistants.
– Use an Invacare approved sling that is
recommended by the individual's doctor, nurse
or medical assistant for the comfort and safety
of the individual being lifted.
– Invacare slings and patient lift accessories are
specifically designed to be used in conjunction
with Invacare patient lifts.
– After each laundering (in accordance with
instructions on the sling), inspect sling(s) for
wear, tear, and loose stitching.
– Bleached, torn, cut, frayed, or damaged slings
are unsafe and could result in injury. Discard
immediately.
– DO NOT alter slings.
WARNING!
Risk of Injury
Improperly attached or adjusted slings can cause
the patient to fall or cause injury to assistants.
– Be sure to check the sling attachments each
time the sling is removed and replaced, to
ensure that it is properly attached before the
patient is removed from a stationary object
(bed, chair or commode).
– The spreader bar MUST be attached to the lift
BEFORE attaching the sling.
– DO NOT use any kind of plastic back
incontinence pad or seating cushion between
patient and sling material that may cause the
patient to slide out of the sling during transfer.
– Make sure that there is sufficient head support
when lifting a patient.
– Position the patient in the sling as directed by
the instructions provided with the sling.
– Adjustments for patient safety and comfort
should be made before moving the patient.
The loops of the sling may be equipped with color coded
straps providing different length, to place the patient in
various positions. Use shorter loops at the back of patient
for upright support. Using longer loops will leave less
support for the patient's back and the patient will be in a
more reclined position. Match the corresponding colors on
each side of the sling for an even lift of the patient.
2-point spreader bar
C
A
1650023-B
D
B
1. Place the shoulder loops A of the sling B over the
hooks C of the spreader bar D.
2. Place the leg loops A of the sling B over the hooks
C of the spreader bar D.
4-point spreader bar
C
C
A
1. Place the loops A of the sling B over the hooks C of
the spreader bar D.

6.3 Transferring a patient from a bed

1. Prepare to lift. See 6.2 Preparing to lift, page 16.
2. Attach the sling to the lift. See 6.2.1 Attaching the sling
to the lift, page 17.
3. Unlock the rear castors.
4.
Lower the bed to the lowest position.
5.
Lift the patient high enough to clear the stationary
object with their weight fully supported by the lift.
The boom will stay in position until the DOWN
button is pressed.
Lifting the Patient
17