Switching On; Switching Off (Standby) - Jura 657 Original Bedienungsanleitung

Switching on

Switching off (standby)

When the IMPRESSA is switched on, a prompt for the rinse operation
automatically appears which is initiated by pressing the rinse but-
ton.
This setting can be changed in programming mode so that the
machine automatically activates the switch-on rinse (see Chapter 5
'Permanent settings in programming mode – Switch-on rinse').
Precondition: Your IMPRESSA is switched on at the power switch.
T Open the cover of the programming buttons.
Q T Press the on/off button to switch the IMPRESSA on.
WELCOME TO JURA appears briefly on the display. After
heating, PRESS RINSE BUTTON is displayed.
c T Press the rinse button to start the rinse operation.
MACHINE IS RINSING, water flows out of the dual spout. The
operation stops automatically. Your IMPRESSA is ready for
operation.
When you switch your IMPRESSA off, the spouts with which a coffee
speciality or milk have been prepared are rinsed. If only hot water or
steam was prepared, the machine switches off without rinsing.
Precondition: Your IMPRESSA is ready for operation.
T Open the cover of the programming buttons.
Q T Press the on/off button to switch the IMPRESSA off.
GOODBYE appears on the display. The machine is rinsed,
water flows out of the dual spout. The operation stops auto-
matically, the IMPRESSA is switched off (standby).
E To disconnect the machine completely from the mains, switch
it off with the power switch on the rear of the machine.
2 Preparing and using for the first time
17