Adding Fuel And Engine Oil - AL-KO Snow Line 620E III Betriebsanleitung

GB
Attaching snow discharge chute hand crank
1. Insert the guide for the hand crank into the
guide handle and tighten. Do not tighten it yet
( 9-1).
2. Slide the hand crank through the guide on
the guide handle.
If it is difficult or impossible to move the
hand crank to the lower guide, it may be ne-
cessary to adjust the guide on the guide
handle slightly. To do this, loosen the screws
slightly and re-tighten after adjusting
( 9 -1).
3. Insert the safety split pin using pliers (
-2).
x The hand crank is attached.
Checking the tyre pressure
The maximum allowed tyre pressure is indicated
on the tyres ( 10 -1). Note: 1 bar = approximate-
ly 14.5 psi
Pump up both tyres to the same pressure level
using the tyre pump.
26

Adding fuel and engine oil

Always follow the instructions in the engi-
ne operating manual provided.
Fuel the snow blower and add oil before use.
Danger - fire hazard!
Petrol and oil are highly flammable!
Fuel and lubricant
9
Type
Filling
quantity
Safety
Warning!
Never leave the engine running in an enc-
losed space. Risk of poisoning!
„ Store petrol and oil only in appropriate containers.
„ Allow the machine to cool before storing it in an
enclosed space.
„ If there is still petrol in the tank, make sure that
there is no ignition source in the enclosed space,
such as a heater or clothes dryer.
„ Add or empty petrol and oil in an open space only
when the engine is switched off and cold.
„ Do not overfill the tank (petrol expands).
„ Do not smoke while filling the tank.
„ Do not open the tank cap while the engine is
running or hot.
„ Replace the tank or cap if damaged.
„ Always secure the tank cap securely.
AL-KO snow blowers
Petrol Engine oil
Regular lead-free SAE 5W-30
petrol (86 octane recommended
or higher)
Engine is E10-
compliant.
4 l 0.95 l
Original operating instructions