Preparing The Machine For Transport; Taking Down The Driver's Cab Roof - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP
5.6.2

Preparing the machine for transport

5.6.3

Taking down the driver's cab roof

Taking down the roof requires two people.
Undo the driver's cab roof on the left and right side of the machine.
47 / 70
Operating the machine
V1
1. Completely empty the hopper.
2. Collapse the adjustable panels. See
"Adjusting the adjustable panels".
3. Fold up the sideway extensions of
the chutes.
4. Take down the smoothing and
spreading board. See "Fitting the
smoothing and spreading board".
5. Raise the entire smoothing board.
See "Raising/lowering the
smoothing board"
6. Remove the manual control unit,
MOBA control unit, ultrasonic and
height sensors and store in a save
place.
7. Move the holder (1) into the
transport position as shown in the
illustration and secure with the
locking lever (2) and (3) and fasten
with the wing screw (4).
1. Fold up the sideway extensions of
the chutes.
2. Pull out the lock bolt (1) and turn.
3. Fold out the feet (2) in the direction
of the arrow.
4. Keep turning the lock bolt (1) until
it engages.
5. Undo the locking lever (3). When
doing so, the roof must be held in
place by another person.
6. Hold on to the driver's cab roof at
the handle (4) and slowly collapse it
towards the front.
EN