Using The Battery Charger To Charge The Battery - Invacare Stand Assist RPS350–1FR Gebrauchsanweisung

4.7.3 Using the Battery Charger to Charge the Battery

This procedure only applies to the RPS350–1E.
1. Lift up on the handle A on the back of the battery B.
2. Lift the battery up and out away from the control box C.
CAUTION!
Mounting the battery improperly may cause
injury or damage.
– Make sure there is an audible click when
mounting battery on the battery charger to
confirm proper mounting.
1078985-I
3. Place the battery on the battery charger D as shown.
Make sure there is an audible click.
The charge LED will illuminate. When charging is
complete, charge LED will stop illuminating.
A battery needing to be fully recharged will take
approximately four hours.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and out away from the battery
charger.
CAUTION!
Mounting the battery improperly may cause
injury or damage.
– Make sure there is an audible click when
mounting battery on the control box to confirm
proper mounting.
6. Reinstall the battery onto the control box as shown.
Make sure there is an audible click.
The battery mounts to the control box and battery
charger as shown.
Usage
23