Using The Battery Charger To Charge The Battery - Invacare Stand Assist RPS350–1E Gebrauchsanweisung

CAUTION!
– The emergency stop MUST NOT be activated -
otherwise it will be impossible to charge the
battery. While charging takes place, the patient
lift cannot be used. DO NOT attempt to move
the patient lift without unplugging the power
cord from the wall outlet. DO NOT attempt
to use the patient lift if the battery housing is
damaged. Replace a damaged battery housing
before any further use.
1. Attach the power cord to the control box.
2. Plug the power cord into a power outlet.
The battery will charge in approximately 4 hours.
Charging must be done in a room with good air
ventilation.
3. Disconnect the power cord from the power outlet after
the battery has been fully charged.
4.7.3 Using the Battery Charger to Charge the
Battery
1078985-K
This procedure only applies to the RPS350–1E.
1. Lift up on the handle A on the back of the battery B.
2. Lift the battery up and out away from the control box C.
CAUTION!
Mounting the battery improperly may cause
injury or damage.
– Make sure there is an audible click when
mounting battery on the battery charger to
confirm proper mounting.
3. Place the battery on the battery charger D as shown.
Make sure there is an audible click.
The charge LED will illuminate. When charging is
complete, charge LED will stop illuminating.
A battery needing to be fully recharged will take
approximately four hours.
4. Lift up on the handle on the back of the battery.
5. Lift the battery up and out away from the battery
charger.
CAUTION!
Mounting the battery improperly may cause
injury or damage.
– Make sure there is an audible click when
mounting battery on the control box to confirm
proper mounting.
6. Reinstall the battery onto the control box as shown.
Make sure there is an audible click.
The battery mounts to the control box and battery
charger as shown.
Usage
11