b) Trimming the model
If the model makes different size turns when you compare left and right turns, and/or if it tends to fly in a gentle curve
the entire time, you can adjust the flight pattern by adjusting the trim slide for direction control (see Figure 2, pos. 4).
If the model constantly flies to the left or if it flies left turns better than right turns, the trim slide is to be adjusted to the
right.
Figure 9
If the model constantly flies to the right or if it flies right turns better than left turns, the trim slide is to be adjusted to the
left.
Figure 10
The small mass of the model and the relatively low flight speed mean that there is usually no problem if the model flies
into something. There is very little likelihood of any damage to the plane or to any furniture, curtains or plants in the
case of a collision.
It is however important that you switch off the motor immediately if a collision occurs.
34