Ransomes HR6010 Handbuch Seite 8

3 SAFETY INSTRUCTIONS
DANGER - Indicates an imminently hazardous
situation which, if not avoided, WILL result in death
or serious injury.
WARNING - Indicates a potentially hazardous
situation which, if not avoided, COULD result in death
or serious injury.
CAUTION - Indicates a potentially hazardous
situation which, if not avoided, MAY result in minor
or moderate injury and property damage. It may also
be used to alert against unsafe practices.
WARNING
Cutting Unit Transport Latches are a Secondary
Safety Devise.
When Transporting the machine the Cutting
units should be held in the Transport position
on the Hydraulics with the Transport Latches
Engaged.
1. Park the machine on level ground.
2. Whilst seated in the driving position With the
engine at operating speed raise the cutting
units fully by operating lift levers, return the
lever to the neutral position.
DO NOT move the lever into the lower
3. Disengage drives, stop the engine and make
sure all moving parts are stationary. Apply
brakes and remove the starter key.
4. Transport latches can now be engaged or
released.
Before releasing transport latches it is
important that all cutting units are fully
raised.
en-6
SAFETY, OPERATORS & MAINTENANCE MANUAL
position.
IMPORTANT: Transport speed is for highway use
only. Never select transport speed on grass
areas or uneven or unsurfaced roads or tracks.
WARNING
California Proposition 65
Engine Exhaust, some of its constituents,
and certain vehicle components contain or
emit chemicals known to the state of
California to cause cancer and birth defects
or other reproductive harm.
WARNING
DO NOT USE ON SLOPES GREATER THAN
15°.
WARNING
Hydraulic Fluid escaping under pressure
can penetrate skin and do serious damage.
Immediate medical assistance must be
sought.
WARNING
Batteries produce explosive gases and
contain corrosive acid and supply levels of
electrical current high enough to cause
burns.