Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Before each flight check that all parts are properly fixed.
The model must always be held in such a way that the propeller is free to
rotate, as it is capable of inflicting injury.
Always switch the transmitter on first, and only then the receiver.
Always switch the receiver off first, and only then the transmitter.
If you neglect this sequence, i.e. if at any time the receiver is switched on when
the transmitter is at "OFF", the receiver will be completely open to other
transmitters, interference etc., and this could cause the motor to burst into life
unexpectedly.
Before every flight ensure that the remote control system is working properly and has
adequate range. This means checking that the transmitter controls the model's
functions at a reasonable range on the ground.
Batteries
Never use faulty or damaged cells or batteries consisting of different cell types,
mixtures of old and new cells, or cells of different makes.
Exhausted and faulty dry or rechargeable cells must not be discarded in the
household waste. Take old batteries back to your model shop, or to your nearest
specialist toxic waste disposal centre.
Gluing different materials
The following table lists typical glued joints and the recommended adhesives. It is
only a guide, and does not claim to be comprehensive.
Materials
Lightweight foam to
lightweight foam
Lightweight foam to
CFRP
Read and observe the instructions supplied with all adhesives! The building
instructions inform you when to use particular glues. If you wish to use white
spirit or other solvent as a cleaning agent, note that special safety measures
are required. Read the instructions supplied with these materials.
Note
Important: it is essential to keep the model's weight to a minimum, so please be
sparing at all times when applying adhesives.
Read the instructions supplied with the various glues before using a particular type
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler!
Typical joint
Wing
Fuselage / tail boom
19
Adhesive
Order No.
UHU por, 959, or
adhesive tape, 693.1
UHU por, 959, or
Styrofoam cyano, 5820
06/2007
Werbung
