Preparing Beverages; Preparing Espresso And Café Crème; Preparing Cappuccino And Latte Macchiato; Preparing Milk Froth And Warm Milk - Melitta Barista TS Bedienungsanleitung

Preparing beverages

2. Remove the coffee grounds container
(8) and empty it.
3. Empty the drip tray.
4. Insert the coffee grounds container.
5. Push the drip tray into the appliance up
to the stop.
Information
The appliance requests you to empty the
drip tray and the coffee grounds container
after a defined number of beverages have
been dispensed. If the containers are emp-
tied while the appliance is switched off, it
does not register this process. Therefore,
it is possible that you are requested to
empty the containers although the drip
tray and the coffee grounds container are
not yet full.
5 Preparing beverages
There are three options for preparing
beverages:
ū Standard dispensing with direct keys
and recipes (BARISTA TS model),
ū Preparation with modified beverage
settings (see chapter 6, page 50)
ū Use of personal settings with the
"My Coffee" function (see chapter 7,
page 51)
Standard dispensing is described in this
section.
Please note:
ū The storage containers should contain
sufficient amounts of coffee and water.
Otherwise the appliance requests you
to refill it.
ū The appliance does not indicate a lack
of milk.
ū When selecting a beverage with milk,
connect the milk container or a com-
mercially available milk pack.
ū The vessels for the beverages should be
sufficiently large.
ū For beverage preparation, the display
must show the ready for use display.
48
ū Beverage dispensing is ended automat-
ically.
ū After a beverage preparation with milk,
the appliance automatically prompts
for the Easy Cleaning programme.
5.1 Preparing espresso and
café crème
1. Place a vessel beneath the outlet.
2. Press the "Espresso" or "Café Crème"
button.
» The beverage is prepared.
3. Remove the vessel.
5.2 Preparing cappuccino and
latte macchiato
Requirement: Milk is connected.
1. Place a vessel beneath the outlet.
2. Press the "Cappuccino" or "Latte Mac-
chiato" button.
» The beverage is prepared.
» The display shows: Easy Cleaning?
(OK for start).
3. Remove the vessel.
4. Run the Easy Cleaning programme or
prepare another beverage and then
carry it out, see section 9.4, page 57.
5.3 Preparing milk froth and
warm milk
The preparation of milk froth and warm
milk is similar.
Requirement: Milk is connected.
1. Place a vessel beneath the outlet.
2. Press the "Milk froth/milk" button.
a) Milk froth = briefly press button
b) Warm milk = press the button for
longer (2 seconds)
» Milk dispensing begins.