C) Cycle Programme ("Cycle") - VOLTCRAFT B6 Duo Bedienungsanleitung

c) Cycle Programme ("CYCLE")

To test or refresh batteries, you can perform up to 5 cycles in sequence. The two possible
combinations are "Charge/Discharge" ("CHG>DCHG") and "Discharge/Charge"
("DCHG>CHG").
• After you have selected the "NiMH" or "NiCd" program in the main menu with the button
"TYPE/STOP" and confirmed this with the button "ENTER/START", you can select the
cycle programme using the button "+" or "-" (illustration shows NiMH battery):
NiMH CYCLE NiMH CYCLE NiMH CYCLE
NiMH CYCLE NiMH CYCLE
CHG>DCHG CHG>DCHG
CHG>DCHG
CHG>DCHG CHG>DCHG
• If you want to switch the charge/discharge sequence or set the cycle number, press the
button "ENTER/START". The text for the sequence now flashes in the bottom line of the
display.
Change the order using the buttons "+" and "-".
NiMH CYCLE NiMH CYCLE NiMH CYCLE
NiMH CYCLE NiMH CYCLE
CHG>DCHG CHG>DCHG
CHG>DCHG CHG>DCHG CHG>DCHG
First the battery is charged and then discharged in the left image. In the right image, this
sequence is reversed, meaning first the battery is discharged and then charged.
• Confirm the selection by pressing the "ENTER/START" button.
• Afterwards the cycle count flashes, meaning how often the presently set sequence of
charge/discharge or discharge/charge operations is performed. You can set a value from
1 to 5 cycles with the buttons "+" or "-". Confirm your entry as usual with the buttons
"ENTER/START".
• To start the cycle, keep the "ENTER/START" button pressed (approx. 3 seconds).
• If the settings are wrong, or if the charger detects a problem, an audio signal is emitted
and the appropriate information is shown on the display.
• Once the cycle is completed, an audio signal is emitted.
If you wish to terminate the cycle beforehand, press the "TYPE/STOP" button.
1 1
1
1 1
NiMH CYCLE NiMH CYCLE
NiMH CYCLE NiMH CYCLE NiMH CYCLE
1 1
1 1 1 DCHG>CHG DCHG>CHG DCHG>CHG
DCHG>CHG DCHG>CHG
1 1 1
1 1
83