Recording A Source - Yamaha RX-V520RDS Bedienungsanleitung

Recording adjustments and other operations are performed
from the recording component. Refer to the instructions for
these components.
D I G I T A L
SURROUND
STANDBY
/ON
BASS TREBLE BALANCE SPEAKERS
A B PROGRAM
+ +
– – L R ON OFF
PHONES
SILENT
2
1
Set the volume at the
minimum level.
2
Select the source you want to record.
INPUT
Front panel
3
Begin recording by the recording component
connected to this unit.
4
Play the source and then turn up the volume to
confirm the input source.
VOLUME
Front panel
34

RECORDING A SOURCE

D I G I T A L
RDS MODE/FREQ EON
PTY SEEK
MODE START
INPUT MODE
PRESET
/TUNING FM/AM
EFFECT PRESET/TUNING A/B/C/D/E
EDIT
TUNING
MEMORY MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
S VIDEO VIDEO L AUDIO R OPTICAL
VIDEO AUX
4
VOLUME
Front panel
or
Remote control
or
Remote control
Notes
• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
1,4
between other components connected to this unit.
• The DSP program and the setting of VOLUME, BASS, TREBLE
and BALANCE have no effect on the material being recorded.
VOLUME
• A source connected to the 6CH INPUT jacks of this unit cannot
be recorded.
• Composite video and S video signals pass independently through
6CH INPUT
INPUT
this unit's video circuits. Therefore, when recording or dubbing
video signals, if your video source component is connected to
provide only an S video (or only a composite video) signal, you
can record only an S video (or only a composite video) signal by
your VCR.
2
• A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from records,
CDs, radio, etc. Recording of copyrighted material may infringe
copyright laws.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
I Special considerations when
recording DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise being
recorded. Therefore, if you want to use this unit to record
sources that have DTS signals recorded on them, the
following considerations and adjustments need to be made.
For DVDs and CDs encoded with DTS
Only 2-channel analog audio signals may be recorded.
Set the DVD player (or CD player) as described in the
player's operation instructions so that the audio signals are
output from the player's analog outputs.