Returning To The Factory Setting - Yamaha RX-V520RDS Bedienungsanleitung

Returning to the Factory Setting

I To return to the factory-set codes
in all modes
1
Press one of the
component selector
buttons other than
AMP(TUNER).
2
Press both VOLUME
buttons (u/d) at the same
time for about four
seconds.
The indicator flashes twice.
3
Enter the code number
"9990".
Make sure that the indicator
flashes twice.
The following codes are factory set.
Component selector button
TV
CBL/SAT
VCR
DVD/LD
CD
TAPE/MD
We recommend that you write all the code numbers you have set on the table above.
Component Code
TV 0101
Cable TV 0006
VCR 0002
DVD player 0008 (YAMAHA DVD player)
CD player 0005 (YAMAHA CD player)
MD recorder 0024 (YAMAHA MD recorder)
I To return to the factory-set codes
in each mode
1
Press one of the
component selector
buttons which
corresponds to the
component to be returned
to the factory-set code.
2
Press both VOLUME
buttons (u/d) at the same
time for about four
seconds.
The indicator flashes twice.
3
Enter the code number
"0000".
Make sure that the indicator
flashes twice.
Set component
PRESET REMOTE CONTROL
Set code
49