Selecting A Dsp Program - Yamaha RX-V520RDS Bedienungsanleitung

PLAYING A SOURCE

Selecting a DSP Program

You can enhance your listening experience by selecting a
DSP program. Refer to "SOUND FIELD PROGRAM" for
details about each program.
y
• Make sure that the sound effect is turned on (see page 25).
I On the remote control
1
1
Press AMP(TUNER) on the
component selector.
2
Press PRG+ or PRG–
repeatedly to select the
desired program.
The name of the selected
program appears for a moment
and the selected DSP program
indicator lights up on the
display.
MOVIE THEATER 1
DIGITAL
DSP
DSP program name
24
2
BASS EXT.
I On the front panel
D I G I T A L
SURROUND
STANDBY
/ON
BASS TREBLE BALANCE SPEAKERS
A B PROGRAM
– + – + L R ON OFF
PHONES
SILENT
PROGRAM
Press PROGRAM l or h
repeatedly to select the
desired program.
The name of the selected
program appears for a moment
and the selected DSP program
indicator lights up on the
display.
MOVIE THEATER 1
DIGITAL
DSP
DSP program name
y
• If desired, adjust the delay time and the sound output level of each
speaker. (Refer to "DELAY TIME AND SPEAKER OUTPUT
LEVELS" on page 40 for details.)
Notes
• Choose a DSP program based on your listening preference, and
not on the name of the program. The acoustics of your listening
room affect the DSP program. Minimize the sound reflections in
your room to maximize the effect created by the program.
• When you select an input source, this unit automatically selects
the last DSP program used with that source.
• When you set this unit in the standby mode, the current source
and DSP program are memorized and are automatically selected
when you turn on the power again.
• If a Dolby Digital or DTS signal is input when the input mode is
set to AUTO, the DSP program automatically switches to the
appropriate decoding program.
• When a monaural source is being played with PRO LOGIC/
NORMAL or PRO LOGIC/ENHANCED, no sound will be heard
from the main speakers and the rear speakers. Sound can only be
heard from the center speaker. However, if "CENTER SP" in the
SET MENU is set to NON, the center channel sound is output
from the main speakers.
• When a source connected to the 6CH INPUT jack of this unit is
selected, the digital sound field processor cannot be used.
• When 96-kHz sampling digital signals are input to this unit, the
DSP program cannot be selected. In this case, the sound is
reproduced as normal 2-channel stereo.
D I G I T A L
RDS MODE/FREQ EON
PTY SEEK
MODE START
INPUT MODE
PRESET
/TUNING FM/AM
EFFECT PRESET/TUNING A/B/C/D/E
EDIT
TUNING
MEMORY MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
S VIDEO VIDEO L AUDIO R OPTICAL
VIDEO AUX
/
PROGRAM
BASS EXT.
VOLUME
6CH INPUT
INPUT