Care And Maintenance - Trotec IC 0120 V Bedienungsanleitung

3 . Turn on the camera time displaced to point 2. You
can see the power indicator of the camera lights
green and flashes blue at the same time. In this
mode, the camera prepares to recognize the
Bluetooth headset.
4 . Press and hold the power button of the Bluetooth
headset for about 2 seconds to the headset and
camera. After conneting succesfully, the headset
power lights green. Then you can see
middle-bottom screen.
5. Now the camera and headset are conected. Next
time, turn on the headset, the power indicator
flashes blue, and then turn on the camera, it is
ready for use it. Press the C key and Enter key
together to deactivate the connection to the Blue-
tooth headset.
6. The headset allows you to record voice memos or
play back memos.

09. CARE AND MAINTENANCE

Use the following procedures to clean the camera
body, lens, LCD monitor and other parts.
Camera Body
Wipe the body clean with soft cloth or eyeglass lens
wiper.
Lens
First use a lens blower brush to remove dust and dirt,
then remove any remaining dirt by wiping the lens
lightly with soft cloth.
Never use synthetic cleaners on the camera body or
lens.
LCD monitor
Use a lens blower brush to remove dust and dirt. If ne-
cessary, gently wipe the LCD monitor with soft cloth
or an eyeglass lens wiper to remove stubborn dirt.
Never rub or press forcefully on the LCD monitor. The-
se actions may damage it or lead to other problems.
Never use thinners, benzene, synthetic cleaners or
water to clean the camera. These substances may
distort or damage the equipment.
on the
Operating manual – Infrared camera
B - 20