Measurement Range; Freezing/ Activating An Image; Setting Analysis Parameters - Trotec IC 0120 V Bedienungsanleitung

• Directory Name
The directory name can be increased from GZSAT
001 -250. This means, for example, that each indivi-
dual object can be assigned a special directory.
WARNING: Do not at any time change the name
of the directory to a directory other than one
of those mentioned above! This could lead to
the memory card not being able to recognize
the directory!
• Trigger Button
Different functions can be allocated to the trigger
button on the grip.

Measurement range

The brightness can be decreased by setting the filter
(filter lens for measurements >1000 °C) on or an op-
tional filter using.
1. Press the MENU/ENTER key.
2. Press Up and Down
arrow on the omni
selector to select [Ma-
nual adj.], then press
MENU/ENTER key.
3. Setting measurement
range.
• Press the
Left or Right 4 ar-
row on the omni se-
lector to select a
range.
• Press the Up or
Down arrow on the
omni selector to set measurement range.
• This option is unavailable when the image
is frozen.
4. After this operation, press the Menu/Enter key to
close the menu window.
3
Operating manual – Infrared camera
Freezing / Activating an image
You can activate / freeze a thermal image by pres-
sing the S key on the selector.
1. Check that the IR camera is in null mode.
2. Press the S key, to
freeze the image.
3. Press the S key
again, then the im-
age is active.

Setting analysis parameters

1. Press the MENU/ENTER key.
2. Press Up and Down
arrow on the omni
selector to
lect [Obj par.], then
press the MENU/
ENTER key.
3. Setting analysis para-
meter.
• Press the Up or
Down arrow on the
omni selector to se-
lect a new field.
• Press 3 Left , Right 4
arrow on the selector
to set the values.
4. After this operation,
press the MENU/ENTER
key to save changes, or
press the C key to clo-
se the menu window
without saving.
se-
B - 12