Mounting Of The Lift Frame: 3 Ways To Get Started; Method With The Fitting Jigs - Dhollandia DH-L Serie Montageanleitung

EN
G M
4) MOUNTING OF THE LIFT FRAME: 3 WAYS TO GET
STARTED
•
There are 3 different fitting methods to fit the frame of the
cantilever HTL:
1. Using the fitting jigs supplied with the HTL. This
method is universal, and can be used for situations
where the platform forms the rear closure of the body
aperture (without rear doors), or stands behind the
vehicle doors. [See §4.1 below].
2. Using the platform lifted in vertical position. This
method is equivalent to method 4.1, with the additional
benefit that it allows to compensate more easily for
any body imperfections (e.g. body slightly out of
square) [See §4.2 below].
3. Using the platform lifted in horizontal position. This
method is particularly suitable for factory built panel
vans, or for vehicles with barn doors (where the door
locks protrude beyond the rear cross member of the
loading floor of the vehicle) [See §4.4 below].
§4.1 - Method with the fitting jigs
•
This method can only be used for standard steel or alumin-
ium platforms, and steel platforms with a round edge
(option S245.R). It cannot be used for platforms with spe-
cial platform hands (option S245).
•
Measure the outside width across the lift arms. This dimen-
sion corresponds with the inside width needed between
the 2 fitting jigs.
•
Mark the centre line of the vehicle on the rear cross mem-
ber of the loading floor, and position the 2 fitting jigs in
such a way that:
1. The distance between the 2 fitting jigs matches the
outside width across the lift arms, and
2. The distance from each fitting jig to the middle line is
equal, so that they are perfectly centred in the rear
body aperture [See Fig. 4.1].
DHOLLANDIA
Rys. 4.1
=
CA
23
=
DHLM
Mx My
41 36