Programming Codes From Other Remote Controls - Yamaha DSP-Z9 Bedienungsanleitung

REMOTE CONTROL FEATURES
5
Press LEARN again to exit from the setup
mode.
LEARN
Notes
• The supplied remote control does not contain all possible
manufacturer codes for commercially available AV components
(including YAMAHA AV components). If operation is not
possible with any of the manufacturer codes, program the new
remote control function with the Learn feature (see below) or
use the remote control supplied with the component.
• If you have already programmed a remote control function for a
button, the function by learning programming takes priority
over the setup manufacturer code function.
• "ERROR" appears in the display window if you press a button
not indicated in the respective step, or when you press more
than one button at the same time.
Programming codes from other
remote controls
If you want to program functions not included in the basic
operations covered by the manufacturer code, or an
appropriate manufacturer code is not available, do the
following. You can program any of the buttons available in
the component control area (see page 80). The buttons can
be programmed independently for each component.
Note
This remote control transmits infrared rays. If the other remote
control also uses infrared rays, this remote control can learn most
of its functions. However, you may not be able to program some
special signals or extremely long transmissions. (Refer to the
operating instructions for the remote control of your component.)
1
Set 10KEY/AMP to 10KEY.
y
It is also possible to program in this unit's control area with
10KEY/AMP set to AMP. However, if you do this, you will
not be able to control this unit and select sound field
programs.
2
Press an input selector button to select a
source component.
V-AUX TUNER PHONO
CABLE SAT MD/TAPE CD-R CD
DTV/LD VCR 1 VCR 2 DVR DVD
82
3
Place this remote control about 5 to 10 cm
away from the remote control for your
component on a flat surface so that their
infrared transmitters are aimed at each other.
4
Press LEARN using a ballpoint pen or similar
object.
Do not press and hold LEARN. If you hold down
LEARN for more than 3 seconds, the remote control
enters the manufacturer code setting mode.
y
Complete each of the following steps within 30 seconds.
Otherwise, the learning mode is automatically canceled. In
this case, press LEARN again.
5
Press the button for which you want to
program the new function.
"LEARN" is displayed.
10KEY AMP
5 to 10 cm (2 to 4 in.)
LEARN
Flashes alternately