Yamaha DSP-Z9 Bedienungsanleitung Seite 37

■ Troubleshooting for the auto setup procedure
Before auto setup
Error message
Connect MIC!
Unplug Phones!
No Setup Menu!
Memory Guard!
During auto setup
Press l / h to display detailed information for individual errors. Select Retry to try the auto setup procedure again.
Error message
E01:No Front SP
E02:No Surr. SP
E03:No Pres. SP
E04:SBR ->SBL
E05:Noisy
E06:Check Surr.
E07:No MIC
E08:No Signal
E09:User Cancel
E10:Internal Err
E11:Complex Err
E12:No Speaker
Cause
Optimizer microphone is not connected.
Headphones are connected.
No setup menu items have been selected.
This setting is protected.
Cause
Front L/R channel signal(s) is (are) not
detected.
A surround channel signal is not detected.
A presence channel signal is not detected.
Only the surround back right channel signal is
detected.
Background noise is too loud.
Surround back speaker(s) is (are) connected,
though surround L/R speakers are not.
The optimizer microphone was unplugged
during the auto setup procedure.
The optimizer microphone does not detect test
tones.
The auto setup procedure was cancelled
because a setting that affects auto setup was
changed during the procedure.
No DSP response.
Multiple errors occurred.
All 9 speakers and 2 subwoofers are not
connected.
Remedy
• Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
• Unplug the headphones.
• Select at least one setup menu item.
• Remove the protection setting for auto setup (see
page 78).
Remedy
• Select the front speakers with SPEAKERS A or B.
• Check the front L/R speaker connections.
• Check the surround speaker connections.
• Check the presence speaker connections.
• Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
• Try auto setup in a quiet environment.
• Turn off noisy electric equipment like air
conditioners, or move it away from this unit.
• Connect surround speakers when using (a) surround
back speaker(s).
• Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
• Check the microphone setting.
• Check the speaker connections and placement.
• Perform the auto setup procedure again.
• Restart this unit, then try the auto setup procedure
again.
• Check the speaker connections and placement.
• Check the speaker connections and placement.
AUTO SETUP
35