Connecting The Power Supply Cord - Yamaha DSP-Z9 Bedienungsanleitung

Connecting the power supply cord

AC IN
AC OUTLETS
AUDIO
IN(PLAY) OUT(REC) IN(PLAY)
DTV/LD CBL SAT VCR 1 VCR 2
VIDEO
DTV/LD CBL SAT IN VCR 1 OUT IN VCR 2
DIGITAL OUTPUT
D-R MD/TAPE DVR ZONE 2
B D
C
OPTICAL COAXIAL
VOLTAGE SELECTOR
VOLTAGE
SELECTOR
AC IN
+
R
–
ONT
A
AUDIO
UT(REC) IN(PLAY) OUT(REC)
PE CD-R DVD DTV/LD CBL
1–MONITOR OUT–2 DVD DTV/LD CBL
S1/S2
DIGITAL OUTPUT
CBL SAT DVR CD-R MD/TAPE DVR
8 9 0 A B C D
(General model)
OUT(REC) IN(PL
OUT IN
S40
(AUD
A
IN(PLAY)
SAT VC
VIDEO
SAT IN VC
ZO
OPTICAL CO
■ Connecting the AC power cord
Plug the power cord into the AC inlet after all other
connections are complete, then plug the power cord into
an AC wall outlet.
CAUTION
Do not use an AC power cord other than the one provided.
Use of other power cords may result in fire or electrical
shock.
■ AC OUTLET(S) (SWITCHED)
U.K. and Australia models .............................. 1 OUTLET
Korea model ............................................................... None
Other models ..................................................2 OUTLETS
Use the outlet(s) to connect the power cords from your
other components to this unit. Power to the AC
OUTLET(S) is turned on and off using STANDBY/ON
(or SYSTEM POWER and STANDBY). The outlet(s)
supply power to any connected component whenever this
unit is turned on. The maximum power (total power
consumption of components) that can be connected to the
AC OUTLET(S) is:
Korea model .................................................................N/A
Other models ...........................................................120 W
■ VOLTAGE SELECTOR
(General model only)
The VOLTAGE SELECTOR on the rear panel of this unit
must be set to your local main voltage BEFORE plugging
into the AC main supply. Voltages are 110/120/220/230-
240 V AC and 50/60 Hz.
■ Memory back-up
The memory back-up circuit prevents the stored data from
being lost even if this unit is in the standby mode.
However, if the power cord is disconnected from the AC
wall outlet, or the power supply is cut for more than one
week, the stored data will be lost.
CONNECTIONS
27