Getting Started; Connecting The Dvb-T Receiver; Mains Supply; First Steps - Schwaiger DSR 6005T Bedienungsanleitung

6. Getting Started

This section explains some settings you will need to make before using the receiver for the first
time.

6.1 Connecting the DVB-T Receiver

Mains Supply

This unit is designed for any common mains voltage (95 to 250 volts AC, no adjustment needed).
TV Set
Connect the TV SCART connector on this DVB-T receiver to the SCART connector of your TV set,
GB
using a commonly available 21-pole SCART cable.
Antenna
Connect the coaxial cable from your antenna system (indoor or outdoor antenna) to the RF IN 1
connector of the DVB-T receiver.
For details, please refer to section 4.3 "Rear Panel Connections".

6.2 First Steps

Verify that the power switch on the back panel is set to "ON".
Press the
"ON" appears on the front display of the receiver and the
language selection menu appears on your TV.
Use the and
receiver to select the language of your choice. Then press
the OK button, a message displays information about the
possible need of powering an active DVB-T aerial antenna. If
you have such an aerial antenna with built-in amplifier,
choose the option "ON" with the
control. If you have a standard aerial antenna without the
need for a power supply, the setting for " Antenna Booster
Power " must be set to "OFF". Pressing OK to start "Auto
Search" (Automatic Channel Search)
If the unit should fail to find available TV channels it
automatically turns to the "Main Menu".Check the active
antenna, the positioning and the cable connection to the
device Select "Installation" in the Main Menu and perform
"Auto Search" once again.
After having successfully searched for available TV
channels the unit turns to TV viewing mode.
In the "General Settings" menu you can perform individual settings that are related to the local
time zone (summertime included), your TV set, and desired language selections. For
adjustments, please use the
menu screens. Leave this menu by pressing EXIT.
button on the remote control or on the receiver.
buttons on the remote control or on the
and
5. System Information
1. Date
2. Software version
3. Firmware
( OTA Software Update)
buttons on the remote
buttons and see the explanations at the bottom of the