Adjusting The Angle Of The Pole Pruner; Mounting The Bar And Chain - Ikra IBKH 33 Gebrauchsanweisung

Insert the drive axle (3) in the extension (5) retainer. The
guide groove (1) must engage with the locking pin (2).
Push the drive axle (3) in until it reaches the mechanical
stop and screw the wing bolt (4) tight.
Subsequently fit the cutting unit with the extension on the
motor unit (see "Fitting the attachment").
Attention: For safety reasons, it is prohibited
to fit any shaft extension to the appliance other
than the extension supplied with it.
When pruning high hanging branches with the chain saw,
branches and sawdust may injure your face and eyes.
Always wear a hard hat with eye guard and protective
gloves, in order to protect your eyes and skin. We recom-
mend well-fitting clothing and safety shoes, in order to
prevent injuries.

Adjusting the angle of the pole pruner

If required, you can set the cutting attachment of the pole
pruner to 7 different positions.
Pull the sprung pin (1) out of the latch (2).
1
2
After setting the desired position, release the sprung pin
(1) again.
Attention: The sprung pin (1) must engage firm-
ly in the latch (2).

Mounting the Bar and Chain

1 Unscrew nut and take off the sporcket cover.
2 Turn tensioning screw (1) anticlockwise until the ten-
sioning nut (2) butts against the left.
The chain is very sharp – wear work gloves to pro-
tect hands from cuts.
3 Fit the chain – start at the bar nose.
GB-23