Linking The Robotic Mower And Docking Station - Viking MI 422.1 Gebrauchsanleitung

Press the OK button.
Connect the power supply unit plug
to the mains, then press the OK
button.
When the perimeter wire is correctly
installed and the docking station is
connected to the mains power supply, the
LED (1) illuminates.
Observe the "Docking station
controls" section, particularly if the
LED does not illuminate as
described. ( 13.1)
116
Lift the robotic mower slightly by the
carrying handle (1) to relieve the weight on
the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
Then press the OK button on the
display.
9.11 Linking the robotic mower and
docking station
The robotic mower can only be
operated if it correctly receives the
wire signal emitted by the docking
station. ( 11.16)
Checking the wire signal may take several
minutes. The red STOP button on top of
the machine terminates the link, the
previous installation assistant step is
called up.
Normal reception
Wire signal OK:
The text "Wire signal OK"
appears on the display. The
robotic mower and the docking
station are correctly linked.
Continue initial installation by
pressing the OK button.
MI 422 PC:
"GPRS" energy mode is activated
following successful linking.
( 11.11)
0478 131 9935 C - EN