Docking Station Connections; Initial Installation - Viking MI 422.1 Gebrauchsanleitung

Item Designation
A Robotic mower
B Docking station
C Power supply unit
D iRuler
E Peg for
docking station
F Puller for carrier plate
−
Instruction manual
−
Corridor template

9. Initial installation

9.1 Notes on the docking station
Requirements for the docking station
location:
– Protected, shady.
Direct sunlight can lead to increased
temperatures in the machine and longer
battery charging times.
A canopy top available as an accessory
can be mounted on the docking station.
This provides better protection for the
robotic mower against the weather.
– Easily visible.
The docking station should be easily
visible in its chosen location to prevent
the risk of tripping over it.
– In the immediate vicinity of a suitable
socket.
The mains connection must be close
enough to the docking station that the
respective power cables can be
connected to both the docking station
and the mains connection – do not
change the power cable of the power
supply unit.
104
– Level and flat.
Qty.
1
1
1
2
4
1
1
1
The docking station must not be inclined
by more than 2 cm rearwards or 8 cm
forwards. Never bend the floor plate. Any
unevenness must be removed under the
floor plate so that it fully contacts the
ground.
Installation options:
The docking station can be installed
internally and externally.
Internal docking station:
The docking station (1) is installed within
the mowing area (A), right at the edge.
There must be a free, level area (2) with a
radius of at least 1 m in front of the docking
station (1). Remove any bumps or
depressions.
External docking station:
The docking station (1) is installed outside
the mowing area (A).
0478 131 9935 C - EN