Adjusting The Disc Guard Cover; Using The Auxiliary Handle; Maintenance And Cleaning - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

Use of accessories / Maintenance and cleaning
Note! These may only be used in combination
with a backing plate!
Cup brush, crimped wire
Dimensions:
Speed:
Cup brush, twisted wire
Dimensions:
Speed:
Cup brush, knotted wire
Dimensions:
Speed:

Adjusting the disc guard cover

Q
Pull the mains plug out of the mains socket
before you carry out any task on the device.
In order to adjust the safety cover
not need to remove the screws
sen them.
48 GB
ø 75–100 mm
min. 12000 rpm
ø 75 mm
min. 12000 rpm
ø 115 mm
min. 12000 rpm
DANGER OF INJURy!
, one does
5
but just loo-
12
5
DANGER OF INJURy! Always use the an-
gle grinder with the disc guard cover
place. The disc guard cover must be securely
attached to the angle grinder. To ensure the
highest level of safety while using the device,
ensure that the smallest possible area of the
grinding or cutting tool is exposed to the oper-
ator at all times (see Fig. C, D). The disc guard
cover is there to protect the operator from
5
pieces breaking off and accidental contact
with the grinding or cutting tool. The disc guard
cover has 5 set positions.
T urn the disc guard cover
position (working position).
The closed side of the disc guard cover
always be facing the operator.

Using the auxiliary handle

Q
CAUTION! For safety reasons this device must
always be used with the auxiliary handle
The auxiliary handle
4
left, right or on the top of the head of the device.

Maintenance and cleaning

Q
Pull the mains plug out of the mains socket
before you carry out any task on the device.
D o not use sharp objects for cleaning
the device. Do not allow any liquids
to enter the device. otherwise the tool may
be damaged.
H ave the carbon brushes replaced only at the
service centre or an accredited electrical
equipment repair centre. The device requires
no other maintenance.
12
in
5
into the desired
5
5
in place.
4
can be screwed on to the
DANGER OF INJURy!
must