Changing A Disc; Use Of Accessories; Cutting / Roughing Discs; Flap Discs For Metal - Parkside PWS 125 A1 Bedienungs- Und Sicherheitshinweise

Changing a disc

Q
Always wear protective gloves
when changing cutting or roughing /
grinding discs.
P ress the spindle lock button
mounting spindle
7
Fig. A.
P ress the spindle lock button
drive.
R elease the clamping nut
, Fig. B.
11
P lace the roughing, grinding or cutting disc on
to the mounting flange
facing towards the device.
T hen replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
7
P ress the spindle lock button
drive.
T ighten the clamping nut
spanner .
11
Note: Replace a new disc immediately if it runs
unevenly or vibrates after being exchanged.
A fter replacing a disc let the device run under
no load for 30 seconds as a safety check.
Look out for unusual noises or generation of
sparks.
C heck that all the fastenings are correctly
attached.
P ay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).

Use of accessories

Q

Cutting / roughing discs

Q
You can use the following cutting or roughing/
grinding discs with this device:
Dimensions:
Speed:
Circumferential speed: 80 m / sec
only after the
9
has reached a standstill,
to block the
9
using the spanner
6
with its labelled side
8
, with its
6
to block the
9
again with the
6
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
min. 12000 rpm
Use / Use of accessories
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
12000 rpm
80 m / sec

Flap discs for metal

Q
Dimensions:
Speed:

Other accessories

Q
You can also use abrasive consumables and tools
complying with the following technical specification:
Spindle thread:
Speed:
Backing plate for grinding discs
Dimensions:
Grinding discs for wood / masonry attached
with hook and eye fixings
Dimensions:
ø 125 mm
min. 12000 rpm
M14
min. 12000 rpm
ø 115 mm / 125 mm
ø 115 mm / 125 mm
GB 47