Changing A Disc; Use Of Accessories; Cutting / Roughing Discs; Flap Discs For Metal - Parkside PWS 125 A1 Originalbetriebsanleitung

and the working conditions and can be deter-
mined by means of a practical test.
The table below shows some recommended
settings (for guidance only and given without
liability) for a number of common applications.
The accessories mentioned may not all be sup-
plied as standard with the product. Sawing stone
is only permitted with the use of a cutting guide
(accessory).
Preselected rotation speed:
Material Application
Plastic, Polishing
varnish
Fine finish
Metal Fine finish
Paint
removal
Wood, Brushing,
metal derusting
Metal, Grinding /
stone abrading
Metal Roughing /
grinding
Stone Cutting
©

Changing a disc

½
Always wear protective gloves
when changing cutting or roughing /
grinding discs.
Press the spindle lock button
mounting spindle
7
Fig. A.
Press the spindle lock button
drive.
Release the clamping nut
, Fig. B.
11
Place the roughing, grinding or cutting disc on
to the mounting flange
facing towards the device.
Then replace the clamping nut
raised side facing upwards, on to the mounting
spindle .
7
All manuals and user guides at all-guides.com
Tool Setting
Lambswool 1
bonnet
Felt polishing 1
disc
Buffing disc 1
Sanding sheet 2-3
Cup brush, 3
sanding sheet
Grinding disc 4-6
Roughing / 6
grinding disk
Cutting disc 6
and cutting
guide
only after the
9
has reached a standstill,
to block the
9
using the spanner
6
with its labelled side
8
, with its
6
Use / Use of accessories
Press the spindle lock button
drive.
Tighten the clamping nut
spanner .
11
Note: Replace a new disc immediately if it runs
unevenly or vibrates after being exchanged.
After replacing a disc let the device run under
no load for 30 seconds as a safety check.
Look out for unusual noises or generation of
sparks.
Check that all the fastenings are correctly
attached.
Pay attention to see that the arrow showing the
direction of rotation on the cutting or roughing /
grinding discs (including diamond cutting discs)
corresponds with the direction of rotation of the
device (see arrow on the head of the device).
©

Use of accessories

©

Cutting / roughing discs

You can use the following cutting or roughing/
grinding discs with this device:
Dimensions:
Speed:
Circumferential speed: 80 m / sec
ø 125 x 22 2 mm
to max 6 mm hick
(dep es ed cen re)
12000 rpm
80 m / sec
©

Flap discs for metal

Dimensions:
Speed:
to block the
9
again with the
6
ø 125 x 22.2 mm
to max. 6 mm thick
(depressed centre)
12000 rpm
ø 125 mm
min. 12000 rpm
GB 15