Torqeedo Ultralight 403 Bedienungsanleitung Seite 63

E07 Motor overcurrent
E08 Circuit board overheating
E21 remote throttle calibration
defective
E22 Magnetic sensor defective
E23 Value range false
E30 Motor communication error
E32 Remote throttle
communication error
E33 General communication error
E41, E42 Incorrect charging voltage
E43 Battery empty
E45 Battery overcurrent
E46 Battery operating temperature
fault
E48 Charging temperature error
Other error Faulty
codes
Nothing Battery does not charge
displayed/ no
flashing during
charging
Continue at low output. Contact Torqeedo Service.
Motor can be used again after a short wait about 10
minutes). Contact Torqeedo Service.
• Re-calibrate:
Press "cal" button for 10 seconds.
• The display shows "cal up":
Press remote throttle lever forward to full gas then
press the "cal" button.
• The display shows "cal stp":
Return remote throttle lever to central (stop) position
then press the "cal" button.
• The display shows "cal dn":
Press remote throttle lever reverse to full gas then
press the "cal" button.
Re-calibrate (refer to E21).
Re-calibrate (refer to E21).
Check the motor cable's plug-in connection.
Check the motor cable for damage.
Check the remote throttle's connections.
Check the cable.
Check the plug-in connections and cables.
Switch the motor off and on again.
Use a Torqeedo power supply. If the fault occurs even
though you are using a Torqeedo power supply, wait
a few hours for the battery to resolve the overcharge
internally. If the fault continue please contact your
Torqeedo service.
Charge battery. Motor can be used again slowly from
the stop position.
Switch motor off and on again. If this error occurs
the battery status indicator and range display can no
longer operate until the battery has been fully charged
again.
Battery cells outside operating temperature between
-20°C and +60°C (-4°F and +140°F).
The motor can be used again when the temperature
has stabilized.
Allow battery to cool; charging will continue when the
cell temperature is between 0°C and +45°C (32°F and
113°F).
Contact Torqeedo Service and notify them of the error
code.
Contact Torqeedo Service.
63