Column With Two Behnke Door Intercoms - Telecom Behnke 5-5501 Anleitung

3.2. Column with two Behnke door intercoms

Height 2.20 m for lorries and cars (example
installation. Please verify the necessary column
height during the design phase.)
1 + 3▸ Fix the door intercom or the module in
question to the column. To do so, please use
the screws provided in the box. Use a clamping
plate to fix the door intercom's lower end.
2 ▸ Fix the cover panel marked "separation
module" below the door intercom's frame with a
clamping plate.
4 ▸ Then fix the cover panel marked "start
module" so that the straight cut edge points
towards the end of the column. The chamfered
edge points towards the Behnke door intercom
device or towards the module frame. Use a
second clamping plate to fix the lower edge of
the cover panel.
5 ▸ Use the cover panel marked "closing
module" to close the remainder of the column.
In case the cover panel is too long, please
shorten it accordingly. Please note that the
distance to the column's base must not be
greater than 5 mm.
6 ▸ When fixing the "closing module", please
make sure that the two drilled holes point up.
The lower edge will be fixed to the column's
base with an angle piece (cf. page 34).
www.behnke-online.de
Instructions for Stainless Steel Vertical Column Installation
Assembling the Vertical Column
Amplifier 7 W
20-0055 or 20-
0056 resp.
Lorries
1 W
Cars
Telephone
connection
15 V power supply unit
20-9585
for camera and
basic electronics
Please provide the corresponding
network cabling for SIP intercom stations.
Directly screw the intercom
station into the column
Module with broad band speakers
21-1107
Professional camera (illuminated)
21-2903
Call button, label
21-2011
Microphone 21-3100
Clamping plate to fix the
intercom station and the
first cover plate or additional
intercom stations.
BT 21-111 door intercom size 3
with a large speaker,
call button, label and
microphone
Cover panels set 3
21-5336
Telephone connection
4 4
15 V power supply
unit 20-9585 for
camera and basic
electronics
coax cable for camera / video feed
or screened and twisted two wire
cable (100m max.)
GB
42