Leds On The Drive Controller (Status Display) - Lenze 8200 motec Montageanleitung

5.2

LEDs on the drive controller (status display)

LED 14 Operating status
red  green ‚
off on Controller enabled
on on Mains switched on and automatic start inhibited
off slowly blinking Controller inhibited
off fast blinking Motor parameter identification being executed
fast blinking off Undervoltage switch−off
slowly blinking off Fault active, check under C0161
1
d c b e a
8
 j g f k i h PS 8888
888
‚ m n o p
88888 q r
Hi m
Hz V A
Lo %sh Ω °C
rpm
z
w x
y
3 4
X3
20 28
Reset the drive controller in this way if a fault occurs (TRIP reset):
1. Plug the keypad onto the AIF interface during operation.
2. Read and take down fault message on the keypad display.
3. Inhibit controller.
4. Disconnect controller from the mains.
5. Carry out a fault analysis and eliminate the faults.
6. Restart the controller.
L
efesotomasyon.com - Lenze
Fault detection and elimination
2 d c b e

j g f k i h
01 61
m n o
p
880Hr
q r
Hi
Lo
‚
5
OFF
EDK82MV752 DE/EN/FR 6.0
Fault messages
a
1
PS
000
m
Hz V A
%sh °C
Ω
rpm
6
ON
 ‚
82mot355
103