I n s t a l l a t i o n o f b o d y p i e c e s
2 The body pieces are first stabilized after 3 clamp clips
have been fitted:
Clamp clip i
Clamp clip a
Clamp clip h
The clamp clips must be screwed from the inside of the body
pieces with washers (5.3 x 14) and Ejot screws (5 x 12):
Attachment
example
clamp clip i
Attention: Make sure that the body pieces are
exactly flush with the clamp clip ends stops!
Silicone free from acetic acid
54
b
Position and letter
a
9 long hole pairs
to attach the
9 clamp clips
Important sealing measures at the front and rear
where both body pieces meet:
3 Check seat of body pieces in angle bracket.
4 Slightly bend left body piece rim to the front, apply approx.
5 – 10 mm behind the body piece edge sufficient silicone
free from acetic acid over the whole height of the rubber
sealing ring. Repeat on the right body piece rim.
5 Do the same on the rear part of the body piece.
c
d
e
of the
g
h
i
f