Werbung
Verfügbare Sprachen
Verfügbare Sprachen
STEP 4:
1. Install the GAS CYLINDER (57) on the SEAT BACK FRAME (5) with 1 BOLT (70), 1 FLAT
WASHER (76) and 1 NYLON NUT (91) by using the WRENCHES provided (112 & 113).
2. Attach the DRINK BOTTLE HOLDERS (39) to the SEAT HANDLE BAR (6).
3. Attach the PEDALS (116) to the CRANK ARMS (51L, 51R). Tighten with the WRENCH
(113). Remember that the LEFT PEDAL has a reverse thread and will be threaded onto the
Crank arm in a COUNTERCLOCKWISE motion. There is an "L" stamped in the end of the
threaded post of the left pedal and an "R" in the right. Make sure to tighten the pedals as
firmly as you can. It may be necessary to re-tighten the pedals if you feel a thumping while
pedaling the bike. A thumping or clicking noise is usually caused by loose pedals.
HARDWARE
#70. 5/16" × 1-1/4"
Hex Head Bolt (1 pc)
#76. 5/16" × 18 × 1.5T
Flat Washer (1 pc)
46
#91. 5/16" × 6T
Nylon Nut (1 pc)
Werbung
