Werbung
SAG SETTING
To achieve the best performance from your FOX suspension, adjust the air pressure to attain your proper sag
setting. Sag is the amount your suspension compresses under your weight and riding gear. Sag range should be
set to 25–30% of total shock travel.
Watch the sag setup video at ridefox.com/sagsetup.
1. Set the 2-position lever to the Open mode, if present.
2. Start by setting the shock air pressure (psi) to match your weight in pounds. With the air pump attached
to the shock valve, slowly cycle your shock through 25% of its travel 10 times as you reach your desired
pressure. This will equalize the positive and negative air chambers and will change the pressure on the
pump gauge.
Do not exceed maximum air pressure: FLOAT X2 air shocks have a maximum air pressure of 350 psi. The shock
pump should not contact the frame or any part of the shock (other than the air valve) during sag setup to prevent
damage.
3. Remove the pump.
4. Sit still on the bike in your normal riding position, using a wall or a tree for support.
5. Pull the sag indicator o-ring up against the rubber air sleeve seal.
6. Carefully dismount the bike without bouncing.
7. Measure the distance between the sag indicator o-ring and the rubber air sleeve seal.
Compare your measurement to the 'Suggested Sag Measurements' table.
8. Cycle the shock 10 times while adding or removing air pressure
until you reach your desired sag measurement.
Suggested Sag Measurements
Travel
55 mm
65 mm
75 mm
WARNING
30% sag (Plush)
DUST WIPER
17 mm
19 mm
22 mm
O-RING
25-30%
SAG RANGE
6
Werbung
