Parkside PDT 40 F4 Bedienungs- Und Sicherheitshinweise Seite 22

z Maintenance
DANGER OF INJURY!
Always disconnect the
device from the compressed air
supply and empty the magazine
before cleaning and/or carrying
out maintenance work.
z Maintenance by the user
Lubricate with the oil-atomiser:
PLEASE NOTE: As a preparatory step,
after the pressure reducer an oil-atomiser
lubricates the air stapler continuously and
in the very best way. An oil-atomiser dis-
penses oil in fine droplets into the airflow
and thereby guarantees regular lubrication.
Fit the oil-atomiser after the (filter)
„
pressure reducer. To do this, plug the
barbed fitting of the oil-atomiser into
the quick coupler of the (filter) pressure
reducer.
Then connect the compressed air
„
device to the quick coupler provided for
this purpose.
Manual lubrication:
PLEASE NOTE: If you do not have an
oil-atomiser, you must lubricate after you
have used approximately 5000 fasteners.
Put 1–2 drops of compressed air
„
special oil into the threaded barbed
fitting of the air stapler.
4
Then press the trigger
„
ATTENTION: Under no circumstances
should you use too much oil, as otherwise
this could leave the mouth with the fas-
tener and this could possibly damage the
workpiece.
22 GB/IE/NI/CY/MT
a few times.
2
z Cleaning
Do not use sharp objects to clean the
„
device and the protective goggles. Do
not allow liquids to get inside the unit –
Otherwise, the device could be damaged.
Clean the device and protective gog-
„
gles regularly. The best time to do so is
straight after completing work.
Clean the device housing with a dry
„
cloth.
Clean the protective goggles with a soft
„
and dry or moistened cloth or clean it
with a cloth moistened with disinfec-
tant – under no circumstances should
you use gasoline, solvents or cleaners
which corrode plastic.
After every use, pack the air stapler,
„
protective goggles and the compressed
air special oil into the carry case deliv-
ered with the product, in order to pro-
tect it from contamination.
PLEASE NOTE: Using, cleaning and
storing the protective goggles can reduce
the service life by approx. 3 years. If the
viewing pane is scratched or there is other
visible damage on the protective goggles,
replace them immediately.
z Information about recycling
and disposal
Do not dispose of the product
including any accessories in
standard household waste, take it
to your municipal collection points
for material recovery.
The packaging is made of
environmentally-friendly material,
which you can dispose of at your
local recycling centres.
Please note the marking on the
different packaging materials and
separate them as necessary. The
packaging materials are marked
with abbreviations (a) and digits (b) with the