Remove chips and dirt particles from the machine after each use with a proper tool.
•
•
Remove chips and dirt particles from the sanding waste containers
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
•
(e.g. WD40 rust inhibitor).
14.2
Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
•
Before each operation, check the perfect condition of the safety devices.
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only proper and suitable tools.
•
•
Use only original spare parts recommended by the manufacturer.
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
before usage
after usage
once a week
monthly
if required
Changing sanding belt
1.
Unscrew the safety screw and open the side coverings plate by turning the lever
2. Turn the cover of the abrasive wheel backwards
3. Release the sanding belt
4. Take out the sanding belt
5. Put in a new sanding belt
6. Reset the sanding belt tension
7. Afterwards close the cover and tighten the safety screw again
8. It is recommended, to adjust the band running a bit rough by pushing the belt to the
sanding surface and turning the adjustment screw
9. Close the cover of the sanding surface and start the machine
10. Readjust the sanding belt run optimally
Changing sanding roll
HOLZMANN MASCHINEN GmbH
Components
•
sanding belt
power cord
•
•
machine
sanding waste container
•
•
motor ventilation slots
bearings
•
•
moveable parts
graphite layer on sanding surface
•
•
sanding belt
• Remove sanding belt in the same way as at changing
• Open the clamping screws (1) until the grinding roll (2)
can be removed and remove it.
• Clean the holder and the new sanding roll
• Insert the new sanding roll in the rigid part of the
holder, then slide the movable part of the holder over
the sanding roll
• Tighten the clamping screws again
• Put in the sanding belt as for changing sanding belt
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
•
check for damage and change if
necessary
•
remove dust and dirt
emptying
•
•
remove dust and dirt
lubricate
•
change
•
•
change
Action
32
MSM100PRO_400V