Bullard DXT Benutzerhandbuch Seite 15

10. IMAGER CONFIGURATION
10.1 ON-SCREEN SETTINGS MENU
The Bullard XT Series Thermal Imagers are equipped with an On-Screen Settings Menu for imager customization. To access the
On-Screen Settings Menu, press and hold both the 'A' and 'B' buttons for approximately 10 seconds. After a few seconds, you will
see a small settings icon along the left side of the display with a count down. Once it reaches 0, the On-Screen Settings Menu will
open.
NOTE:
If you exit from this screen by
pressing the power button, the
temperature unit will not reset.
NOTE:
To change the temperature unit of
the temperature threshold in
Thermal Throttle, you must
reboot your imager after changing
the temperature unit with the
On-Screen Settings Menu.
10.1.1 Navigating the On-Screen Settings Menu
To navigate the On-Screen Settings Menu, short press 'A' to scroll down, short press 'B' to scroll up,
and long press 'A' to select. When using 'A' to scroll down, if you get to the bottom of the list, it will
automatically come back to the top. Likewise, when using 'B' to scroll up, if you get to the top of the
list, it will automatically come back to the bottom. To exit the On-Screen Settings Menu, use the Exit
menu item or tap the power button to return to standard operation.
10.1.2 Changing Settings with the On-Screen Settings Menu
With the On-Screen Settings Menu you will be able to
• Change the Temperature Unit
• Change the Date and Time
• Reset your imager back to factory default
10.1.3 Changing the Temperature Unit
Your imager will come standard in Fahrenheit. If you want to change so temperatures are displayed in
Celsius, follow the instructions below.
1. Turn on your thermal imager and enter the On-Screen Settings Menu by pressing and holding
both the 'A' and 'B' buttons for approximately 10 seconds. After a few seconds you will see a
small settings icon along the left side of the display with a count down. Once it reaches 0, the
Settings Menu will open.
2. Short press the 'A' button to scroll down to "Modify Temperature Unit". Long press 'A' to select.
3. Long press 'A' to select the current temperature unit. You must select the current temperature
unit to change it.
4. Short press 'A' or 'B' to change your temperature unit. Once the temperature unit displayed is
correct, long press 'A' to select.
5. Short press 'A' to scroll down to "Exit and apply changes". Long press 'A' to select.
www.bullard.com
Bullard DXT Thermal Imager
TM
User Manual
15