Progress PCD46103X Benutzerinformation Seite 21

12.2 Removing the shelf supports
Remove the shelf supports to clean the
appliance.
1. Turn off the appliance and wait until it is
cold.
2. Carefully pull the shelf supports up and
out of the front catch.
3. Pull the front end of the shelf support
away from the side wall.
4. Pull the supports out of the rear catch.
1
2
Install the shelf supports in the opposite
sequence.
12.3 Submenu for: Cleaning
The submenu with cleaning functions is under
the sensor field .
S1 Tank Emptying
Procedure for removing the residual water
from the water drawer after use of the
steam functions.
S2 Steam Cleaning
Cleaning the appliance with steam.
S3 Descaling
Procedure for cleaning the steam genera‐
tion circuit from residual limestone.
S4 Rinsing
Procedure for rinsing and cleaning the
steam generation circuit after frequent use
of the steam functions.
12.4 How to use: Tank Emptying - S1
The cleaning function removes the residual
water from the water drawer. Use the function
after the steam cooking function.
1. Make sure the appliance is cold.
2. Remove all accessories and removable
shelf supports.
3. Turn on the appliance.
3
4. Place the deep pan on the first shelf
position.
5. - press repeatedly until the display
shows S1.
6. Press .
Duration: 6 min
7. When the function ends, remove the deep
pan.
When this function works, the lamp is off.
12.5 How to use: Steam Cleaning - S2
1. Make sure the appliance is cold.
2. Remove all accessories.
3. Clean the bottom of the oven interior and
the inner door glass with a soft cloth with
warm water and a mild detergent.
4. Fill the water drawer to the maximum
level (around 950 ml of water) until the
signal sounds or the display shows the
message.
5. - press repeatedly until the display
shows Select S2.
Duration: 30 min
When this function works, the lamp is off.
When the cleaning ends the signal sounds.
6. Press any symbol to turn off the signal.
7. Turn off the appliance.
8. When the appliance is cold, dry the oven
interior with a soft cloth.
9. Leave the oven door open and wait until
the cavity is dry.
12.6 Cleaning reminder
When the reminder appears, cleaning is
recommended.
Use the function: S2.
You can enable and disable the reminder in
the menu: Settings .
12.7 How to use: Descaling - S3
When the steam generator operates, there is
an accumulation and deposition of limestone
inside because of calcium contents in the
water. This can have a negative effect on the
steam quality, on the performance of the
steam generator and on the food quality. To
prevent this, clean the steam generation
circuit from residual stone.
1. Make sure the appliance is cold.
ENGLISH 21