Equipping The Incident Light Turret Disc - Leica LMD6500 Bedienungsanleitung

6. Description and assembly of the components
Attention!
Connect the light guide at both ends (light
source/adapter) before opening the shutter
or attenuator.
The emitted light may result in eye or skin in-
juries or damage to materials.
Never look directly into the light emitted by
the light guide.
• Connect the Leica EL6000 compact light source
to a separate socket (own phase).
Further information → Leica EL6000 manual.
Fig. 17 Filter cube
front side
Fig. 19 Removing the front cover
1 Filter receptacle
2 Retention pin
3 Front cover
22
Fig. 18 Filter cube
back side
1
2
3
6.8

Equipping the Incident Light Turret Disc

The receptacles on the turret are numbered. Ac-
cording to your equipment, the individual fi lter
and/or refl ector cubes have already pre-assigned
positions. A list is provided along with your ship-
ment (" Identifi cation sheet").
Insert the fi lter and refl ector cubes in the follow-
ing manner:
• Equip the incident light turret only when the
microscope is switched off.
• Remove the front cover from the upper part of
the microscope (Fig. 19). Push the retention pin
(19.2 ) to move the turret.
Releasing the retention pin locks the turret.
• Insert the fi lter or refl ector cube into the
mounting in front of you according to the iden-
tifi cation sheet provided.
To do so, place the fi lter or refl ector cube on
the right side and press it to the left into the
mounting (Fig. 20).
Fig. 20 Inserting the fi lter or refl ector cubes
1 Mounting
1