Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
CLEANING THE HOB, BURNERS AND ACCESSORIES
Avoid leaving the components dirty for long
and, periodically,according to the intensity of
work (if necessary daily),proceed as indicated
below:
Switch the appliance off and leave it to cool.
1)
Remove the grill, the burner cap (A) and the
2)
burner (B).
Put them to soak in hot water with dishwash-
3)
er soap.
Wash with a normal sponge and if necessary
4)
a scourer to remove any dirt thoroughly.
Check that the holes of the burner cap (A)
5)
are always completely clear for the regular
fl ow of gas. To remove possible dirt, insert
a metal rod (wire) into the hole and slide it
through until it is thoroughly clean.
Check the burner (B) ignition slot (cutoff ) is
6)
always completely clear for the normal fl ow
of gas. To remove any dirt, insert a blade like
a trimming knife in the slot, sliding it around
until it is thoroughly clean.
Carefully clean all the connecting parts be-
7)
tween the burner cap (A) and the burner (B).
If necessary use a steel wire brush for me-
chanics.
Clean every part of the hob with a suitable
8)
de-greaser.
To carry out this operation, proceed as follows.
Remove the bottom plate (A) and the grid (B)
1)
from the oven and clean them thoroughly.
Clean the inside parts of the oven to remove
2)
any deposits which may impair its operation.
Dry the surfaces and reassemble the compo-
3)
nents.
24
Dry the surfaces and reassemble the parts.
9)
For the correct assembly of the burner (B)
and burner cap (A), follow the directions giv-
en in the illustration.
Turn on the burners for a few minutes to
10)
ensure a thorough drying and thus avoiding
the formation of rust.
WARNING: Do not wash cast iron
parts such as the burners, burner caps and
grids in a dishwasher.
WARNING: Never pour water or allow
dirt to fall into the burner as this will cause a
fault in the burner or block the nozzle.
CLEANING OVEN
B
A
SERVICING
3320050_ut_GB_rev.2
Werbung
