Commissioning; Operation - Stahl SolConeX 8570/11 Serie Betriebsanleitung

8

Commissioning

Explosion hazard due to incorrect installation!
Non-compliance results in severe or fatal injuries.
• Check the device for proper installation before commissioning.
• Comply with national regulations.
Damage or destruction of the device by arc and high pressure is possible if
improper switching operations are used!
Non-compliance can result in severe or fatal injuries.
• Quickly switch the device on and off completely.
• Avoid switching positions between 0 and I (ON and OFF).
Before commissioning, ensure the following:
• Check the mounting and installation.
• Enclosure must not be damaged.
• If necessary, remove foreign bodies.
• If necessary, clean the connection chamber.
• Check if the conductors have been inserted correctly.
• Check if all screws and nuts have been tightened firmly.
• Check whether all the cable entries and stopping plugs have been tightened firmly.
• Check if all conductors have been clamped firmly.
• Observe the line voltage.
• Seal the unused cable entries with plugs certified according to Directive 2014/34/EU
or IEC and unused drilled holes with stopping plugs certified according to Directive
2014/34/EU or IEC.
9

Operation

The wall-mounting socket may only be operated when fully mounted.
The wall-mounting socket can be switched only with the plug inserted.
If the plug has been disconnected, close the hinged cover with the bayonet
ring.
Only type 8570/12 and 8575/12 plugs from R. STAHL may be used.
The degree of protection of the 8575/12 plug is reduced to IP55 when plugged in.
150646 / 8570601300
2017-07-19·BA00·III·en·07
All manuals and user guides at all-guides.com
DANGER
WARNING
SolConeX Wall-Mounted Socket, 16 A
Series 8570/11
Commissioning
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
15