Switching On - ETNA AFI8532ZT Anleitung

OPERATION

Switching on

• Open the door to the dishwasher.
• Press the 'on-off' button (1) to switch on the device.
The check light End Program (4) is on |
• Select the desired program (see 'program selection table').
Select a cycle using the programming button (2).
The check light that is part of the selected program is on.
• Close the door to the dishwasher.
The dishwasher will automatically start running the selected cycle.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the 'delayed start' button (3). You can choose between a delay time of
3, 6 or 9 hours. Each press of the button (3) changes the delay time.
The indicator of the selected delay time is on.
Then select the desired program and close the door of the dishwasher.
Pre-rinse
The pre-rinse program helps you improve the cleaning result for extra
dirty dishes. You can set this program both independently from and in
combination with another program.
Indicators (4)
• Water softener.
The indicator shows that you have to fill the salt container with
regeneration salt.
• Detergent.
The indicator shows that you have to fill the detergent reservoir.
• End program.
The indicator shows that the washing program has finished.
In addition, you will hear a sound signal five times.
EN 7