Switching On - ETNA AFI8538 Anleitung

OPERATION

Switching on

1
2 3
4
• Open the door to the dishwasher.
• Press the 'on-off' button (1) to switch on the device.
The check light End Program (8) is on |
• Select the desired program (see page xx program selection table).
Select a cycle using the programming button (3).
The check light that belongs to the selected program is on.
• Close the door to the dishwasher.
The dishwasher will automatically start running the selected cycle.
The remaining program time appears on the display.
Delayed start time
If you want the dishwasher to switch on at a later time, you can used
the 'delayed start' button (4). You can choose between a delay time of
1, 2... 19 hours. Each press of the button (3) changes the delay time.
The display (2) shows the delayed start time.
Then select the desired program and close the door of the dishwasher.
Selecting a half load
Press the 'half load' button (7) to activate the half load cycle. In the half
loading program, you can use both the upper and lower basket and
both baskets simultaneously.
For a small quantity of dirty dishes, in both the upper and lower basket,
repeatedly press the 'half load' button until the indicators of upper and
lower basket light up.
5 6 7 8
EN 7