ETNA AFI8532ZT Anleitung Seite 8

OPERATION
Stopping or changing a wash cycle
Open the door.
Press and hold the programming button (3) for more than 3 seconds.
The 'End Program' indicator is flashing.
Close the door of the dishwasher.
The machine pumps out for about 30 seconds Following the end of this,
a sound signal will click 5 times and the indicator shows that the program
has finished.
You can now select the desired program again (see page xx 'program
selection table'). Now close the door.
Note! A cycle that has already begun can only be changed in the start-
up phase. After this, the detergent will be sprayed all over the dishes or
the machine may have already pumped out the water. In that instance,
you must refill the detergent compartment (see section on Dishwasher
detergent).
Warning!
Opening the door fully during the wash cycle is dangerous. You may be
splashed with hot water from the machine.
Following the end of the wash cycle
After the washing program has finished, the 'End program' indicator
is flashing and a sound signal will click 5 times. Open the door of the
dishwasher Switch off the device with the on/off button (1).
Wait a few minutes before unloading the dishwasher. The dishes
and cutlery will still be very hot immediately following the end of the
cycle. There is a chance that dishes may break as a result of the
heat. Moreover, the dishes dry better when allowed to stand for a few
minutes.
Flood protection switch
Your dishwasher is fitted with a safety switch that prevents too much
water from running into the appliance. The safety switch closes the
inlet valve and instructs the dishwasher to pump out the surplus
water. If there is water in machine (due to too much water being fed in
previously, or as a result of a leak), this must first be removed before the
appliance is switched on again.
EN 8