Making Sausage - Gastroback DESIGN FLEISCHWOLF PRO M Bedienungsanleitung

•

Making sausage

Use the separator disc and the sausage horn.
Place the separator disc over the worm shaft. The separator disc settles into the cutter
housing only in one way. Thus, ensure that the notch at one side of the brim of the sepa-
rator disc fits onto the protrusion of the cutter housing.
Then place the sausage horn on the separator disc. The wide brim of the sausage horn
must lie firmly on the separator disc.
• Making Kebbe (Middle Eastern meat pâté)
Use the plastic finger and the cone. Place the plastic finger on the worm shaft. The pla-
stic finger settles into the cutter housing only in one way. Thus, ensure that the notch in
the brim of the plastic finger fits onto the protrusion of the cutter housing.
42
Then place the cone on the plastic finger. The wide brim of the cone must lie firmly on
the brim of the plastic finger.
• Preparing Cookies
Use the separator disc, cookie maker and former.
Place the separator disc over the worm shaft. The separator disc settles into the cutter
housing only in one way. Thus, ensure that the notch in the brim at one side of the sepa-
rator disc fits onto the protrusion of the cutter housing.
Then place the cookie maker on the separator disc. The notch in the brim of the cookie
maker must fit into the protrusion on the brim of the separator disc.
Tip:
The former is installed later on.
4. Place the screw ring on the cutter housing, and screw the screw ring clockwise on
the cutter housing, but do not fasten it.
5. Connect the cutter housing to the motor housing.
For this, hold the feed tube pointing to the right (about 45°), and in this orientation insert
the opening of the cutter housing with the cogwheel of the worm shaft into the gear hole
of the motor housing. For this, turn the cutter housing slightly, until it settles in the gear
hole. Do not use violence! If you cannot insert the cutter housing correctly, simply loosen
the screw ring a little, and try again.
Then turn the cutter housing counter clockwise until the feed tube points up vertically and
43