Configuration; Operation; Instructions For Use; Entering Service Data - Bosch ACS 553 Originalbetriebsanleitung

5.16.2 Configuration
To configure the CoRe function (only displayed if
enabled in the Setup Menu), follow this procedure:
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Connected Repair [CoRe]. The display
shows three selection options:
+
Settings: to configure the connection to the CoRe
server. The data to enter is as follows:
$
Host address: is the IP address of the CoRe
server.
$
Host port: is the server port used for the
connection, typically the port number is set to
59487 by default, but it is possible to check this
parameter on the CoRe server in the Settings -
Computer Overview section.
$
Password: is the password (Interface password)
set during the installation of the CoRe server.
5. Confirm the entered data with
"
ACS 553 will try to connect to the CoRe server to
check that all parameters entered are correct.
5.16.3

Operation

To use the CoRe function:
+
Select available A/C task: to select and perform
A/C services previously registered at CoRe server
level. After connecting the ACS 553 to the CoRe
server using the settings described above, it is
possible through this item to select one of the
available A/C services and perform it on the
desired vehicle. Once the A/C service is selected
and performed, the ACS 553 will send a report to
the CoRe server that will automatically save the
result and all data related to it.
+
Create new A/C task: to create an A/C service from
the ACS 553 and assign an Air Conditioning Service
to one of the active vehicles in the workshop.
Selecting this item will display the list of all
active vehicles in the workshop and registered on
the CoRe server regardless of whether or not a
specific A/C service has been requested. When the
vehicle is selected, the ACS 553 will send a special
command to the CoRe server so that the latter
registers that an A/C service is being performed on
the selected vehicle. At the end of the A/C service,
a detailed report will be sent to the CoRe server
that will save it and make it available for displaying
or printing.
Robert Bosch GmbH
6.
6.1
i
After selecting any service function, it is possible
to enter information about the vehicle in order to
allow printing the automatically compiled final
receipt.
1. The display shows
Enter vehicle data
Make: ____________________________
Model: ___________________________
Plate: ___________________________
VIN: _____________________________
MILEAGE: _________________________
Operator: ________________________
i
Use the arrow buttons to move between the rows
. and the multi touch keypad to enter the text.
2. Select
i
This page also shows the Database icon to allow
the user to select a vehicle from the European or
Personal Database if available. If this selection is
made, the BRAND and MODEL fields will be filled
out automatically.
!
Make sure to comply with the standards regarding
the protection of personal data in your state.
Initial settings | ACS 553 | 51 |

Instructions for use

Entering service data

to save the data for the print report.
1 689 989 627
en
|
2021-03-01