General Advice For Operation - Westfalia MNF1700 Originalanleitung

General Advice for Operation

Only use the machine for dry cutting in stone.
Always use the additional handle bar (10). The thread of the additional handle bar
has a left turn cut to ensure that it does not loosen unintentionally during
operation.
1. Before starting to work check your working area for hidden electric lines, gas
and water pipes with a metal detector.
2. Set the desired cutting width. To do so loosen the locking screw (4) and set
the depth stop accordingly (6). Retighten the clamping screw.
3. Hold the machine with both hands and switch it on. Set the machine with the
front edge of the supporting table touching the masonry and lower it slowly
until the support lies flat on the masonry.
4. Cut the groove by pulling the machine slowly in the indicated direction.
Attention! Only perform straight cuts. It is not possible to cut in curves.
5. At the end of the groove, first lift the machine out and then switch off.
6. Allow the machine to come to a halt before putting down. The cutting discs
become very hot during use. Do not touch them until they are cooled down
completely.
7. Use the supplied paring bar (14)l to break out the remaining strip between the
grooves in the masonry.
Operation
17