Assembly And Operation; Before First Use; Start-Up; Converting The Saw - Westfalia TKG 210/30 Originalanleitung

Before first Use

Take the bench saw and all accessory parts out of the package. As transport protection a
Styrofoam block is wedged in the machine. Remove it before setting up the machine.
Please make sure all parts are present.
Dispose of packaging materials or store it out of reach of children. Plastic bags etc. may become a
deadly toy for children.

Start-Up

1. During operation the bench saw must be solidly attached to a firm and even surface. If the
machine is just placed on a workbench and not attached, it might move during operation.
2. The machine is delivered with three additional supports. The two lateral work piece supports
are inserted into the holes on the sides and the rear support is inserted from the rear with the
angled portion facing down. Secure the supports with the clamping screws.
3. Before connecting the machine to the power mains, please make sure the mains voltage in
your area corresponds to the operating voltage stated on the type label. If you are using a
cord reel as an extension cord, please roll the cord off the reel completely, because
otherwise the coiled cable on the reel may overheat and become damaged.

Converting the Saw

Before converting the saw disconnect it from the power supply!
The convert the saw from a table saw to a crosscut and metre saw loosen the
turnknobs (15a and b) and set the table to the highest position. Lock the table in place
with the turnknobs. Lightly press down the upper part of the saw by the handle and
pull out the retaining pin (17). Allow the upper part of the saw to swing up and take out the
Protective tub (19).
To convert the saw from a crosscut and mitre saw to a table saw set the cutting angle along both
axes exactly to zero. Place the protective tub (19) on the turn table and hook it into the fence.
Without the protective tub (19) the saw can and may not be used as a table saw! Press the
unlocking button (2) and push down the upper part of the saw and hold it in the lowest position.
Push the retaining pin (17) in to secure the upper part. Loosen the turnknobs (15) and set the table
to the lowest position and secure it by tightening the turnknobs.

Assembly and Operation

11