Storage; General Storage Instructions; Storage During Working Breaks; Transport - Parkside PBS 2 A1 Originalbetriebsanleitung

Storage

General Storage Instructions

• Clean the equipment and accessories
carefully before storage.
• Keep the equipment in a dry and dust-
proof place out of reach of children.
• Do not wrap the equipment in plastic
bags, as damp and mould may form.
• Do not lie the device down on the pro-
tective cover.
Storage During Working
Breaks
Non-observance of the storage in-
structions can cause starting problems
or permanent damage as a result of
fuel residues in the carburettor.
In case of working breaks of less
than 3 months:
1. Drain the fuel tank (7) in a well-ventilat-
ed place.
2. Start the engine and allow it to tick
over until the engine stops and the car-
burettor is free of fuel.
3. Allow the engine to cool (approx. 5
minutes).
In case of working breaks of more
than 3 months:
4. Loosen the spark plug (
spark plug wrench (
ing/Adjusting the Spark Plug").
5. Pour a teaspoon of pure 2-stroke oil into
the combustion chamber and pull the
starter cable slowly several times to dis-
tribute the oil inside the engine.
6. Reinsert the spark plug (
44) with a
J
23) (see "Chang-
A
44).
J

Transport

• When it is being transported, the
device must be switched off and the
spark plug connector (
Do not transport the device when it is
idling.
• Carry the device with one hand on the
upper shaft tube and the other hand on
the lower shaft tube (
to avoid coming into contact with dan-
gerous parts when transporting it (e.g.
hot engine, cutting unit).
• Use the blade guard (
transporting the blades.
• Maintain a safe distance from other
people when transporting the device.
• Do not transport the unit upside down,
as otherwise fuel might leak out.
Disposal /
Environmental
Protection
Do not allow used oil and petrol residues
into the sewer system or drains.
Dispose of used oil and petrol residues
in an environmentally friendly way – take
them to a disposal point.
Take the equipment, accessories and
packaging for environmentally friendly
recycling.
Machinery does not belong in domestic
waste.
Drain the petrol tank carefully and take your
equipment to a recycling point. The plastic
and metal components used can be separat-
ed by type and therefore recycled. We will
dispose of the defective equipment you send
in, free of charge. Ask your Service-Center
about this.
GB MT
2) removed.
A
8+12) in order
A
59/60) when
A
71