GB
MT
Adjusting the Carburettor
The carburettor is preset in the factory for
optimal performance. If subsequent adjust-
ments are required, have them carried out
by a specialist workshop.
Removing blockages
Switch the device off and re-
move the spark plug connec-
tor before you work on the
cutting unit.
Wear protective gloves in order to
avoid cutting yourself.
Table "Maintenance Intervals"
Machine Part
Screws, nuts, bolts
Air ilter
Fuel ilter
Spark plug
Fuel hoses
Complete machine
Operating handle
Cutting head
Coupling
Lubricating the
70
Action
Check, tighten
Clean or replace
Replace
Clean/adjust/replace
Check, replace if necessary
Check, clean if necessary
Check for function
Check correct installation
Check that the device is sta-
tionary when idling
gears
Checking the coupling
Place the device on a irm level sur-
face. Make sure that the cutting tool
does not touch either other objects
or the ground.
Before each use, check that the coupling is
working correctly when idling.
Start the device (see "Starting the en-
gine") and carry out a visual check at a
suficiently safe distance to verify that the
thread spool is not turning when the device
is idling.
Maintenance Intervals
Regularly carry out the maintenance work
listed in the "maintenance intervals" table.
Regular maintenance prolongs the life of
the equipment. It also gives optimum cut-
ting performance and avoids accidents.
Before
Each Use
Operating Hours
10
20